__          __  __  __   _____         __  __    ____    _____    ____     ____   __   __
\ \        / / |  \/  | |  __ \       |  \/  |  / __ \  |  __ \  |  _ \   / __ \  \ \ / /
 \ \  /\  / /  | \  / | | |  | |      | \  / | | |  | | | |  | | | |_) | | |  | |  \ V / 
  \ \/  \/ /   | |\/| | | |  | |      | |\/| | | |  | | | |  | | |  _ <  | |  | |   > <  
   \  /\  /    | |  | | | |__| |      | |  | | | |__| | | |__| | | |_) | | |__| |  / . \ 
    \/  \/     |_|  |_| |_____/       |_|  |_|  \____/  |_____/  |____/   \____/  /_/ \_\

                   M O D   B O X   M K I I   F I R M W A R E

----------------------------------------------------------------------------------------------------------------------------
UPDATE PROCEDURE

Mod Box MKII updates its firmware from a micro SD card. The bootloader checks the card every time the module powers on.
Update files are named "UPDv***.BIN", where *** is the firmware version (for example UPDv107.BIN is version 1.0.7).

1. Extract the "UPDv***.BIN" file from the zip file.
2. Copy "UPDv***.BIN" to the root directory of a FAT formatted micro SD card.
       - Only ONE "UPDv***.BIN" file may be on the card. Delete any older update files first.
         If more than one is present the update is skipped and the current firmware boots.
3. With Mod Box MKII powered down, insert the micro SD card into the slot on the module.
4. Power the module on. The 3P1, 3P LFO, Skew Free and Skew Rate LEDs show update progress:
       - Fast blink (all four)   : Erasing old firmware
       - Progress bar (1 to 4)   : Writing new firmware
       - Chase                   : Verifying
       - Three fast blinks (all) : Update complete, module boots normally
5. Wait until the module boots to its normal operating state before powering down or removing the SD card.
   The update takes a few seconds.
6. Power down and remove the SD card. You do not need the SD card in the module during normal operation.

Error States:
If the LEDs settle into a steady blink after an update attempt, the update did not complete:
       - 1 LED blinking  : Update file is invalid
       - 2 LEDs blinking : Update file failed verification (re-download and copy the file again)
       - 3 LEDs blinking : Flash write error
Power cycle with a known good "UPDv***.BIN" on the card to retry. User settings and calibration are stored
separately and are not affected by an update.

----------------------------------------------------------------------------------------------------------------------------

MOD BOX MKII V1.0.7 CHANGELOG

Bug Fixes:
- Skew LFO now stays unipolar when clock-synced. Previously a unipolar Skew went bipolar as soon as the
  SK Freq pot was moved off full CCW while synced.
- Analog noise level calibration is now applied reliably at power-on.


----------------------------------------------------------------------------------------------------------------------------
